Posted 7 Jun 2017 (edited) Hello , I'm using DVP12SE11R Delta PLC . I would like to read data from an external device using RS485 communication. In the WPLSOFT i have informed that i gotta use MODRD command in order to read the data . but i am not sure how to use it properly. the data is formed as one bit ('1' or '0') i wanna read 10 registers using MODRD although those registers are not ordered one after another and i know MODRD can read 6 registers one after another. Then i would like to use that bit as a Normally Open contact in the WPLSOFT and turn on a coil. i would like to get some help with it. thanks. Edited 7 Jun 2017 by Omerd Share this post Link to post Share on other sites