_Pavel_

Exchange CQM1-ID213 to CJ1W-IDxx - front connectors

4 posts in this topic

Dear colleagues,

could you please give a tip

need to exchange CQM1-ID213 to CJ1W-IDxx. CQM1-DI213 has a frontal connector, and, respectively, in the existing installaition the Omron extension cable and terminal board are used (can't identify the part numbers, unfortunately, pls see the picture). Is it possible to select a CJ1W-IDxx module with the same frontal connector as CQM1-ID213 has, so I could leave old Omron cable and terminal board (to avoid rewiring). CJ1W-IDxx has options of MIL or Fijitsu connector. Which one is directly exchangeable with CQM1-ID213 connector?

Thank you!

 

CQM1-ID213 front connector.jpg

Share this post


Link to post
Share on other sites

The CQM1 series and CJ series are different hardware platforms. They are not interchangeable.

 

Share this post


Link to post
Share on other sites

_Pavel_,

I am understanding from your post that you want to replace the entire CQM1 system with CJ2 platform.

If that is the case, the CQM1-ID213 used the Fujitsu connector.  The CJ1W-ID231 uses the same connector.

You will need to verify the pinouts, not sure they are identical.

You can find the information in the W226 manual for the CQM1 and the W393 manual for the CJ series.

Share this post


Link to post
Share on other sites

Thanks for help!

Yes, I want to replace the entire PLC! Sorry for being not so exact.

Edited by _Pavel_

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now