Posted 8 May 2017 I have Omron CP1H PLC with Ethernet Option Board Installed on Slot 1. I want To communicate PLC to SCADA software through Kepserver OPC. But I am Not ABle to communicate with PLC on Kepserver OPC. Anyone Know Solution For This? Architecture is attached for more details. Share this post Link to post Share on other sites
Posted 8 May 2017 In Kepware, did you configure your channel as Omron FINS Ethernet and the device as CJ2? Share this post Link to post Share on other sites
Posted 8 May 2017 Thanks For Ur Reply Mr.Pfort, I have configured device as CJ1 in kepware. Actually i am able to Connect to kepware on local network(i.e. 10.11.87.xx) but not able to connect on different network (i.e. 10.11.90.xx) . Share this post Link to post Share on other sites
Posted 8 May 2017 Is that managed switch a router? If not, they are 2 separate networks. A managed switch is not typically a router. Share this post Link to post Share on other sites
Posted 8 May 2017 What is your subnet mask? If it is 255.255.255.0 and that managed switch is not a router as Crossbow has suggested, then this will not work. Share this post Link to post Share on other sites
Posted 9 May 2017 17 hours ago, Crossbow said: Is that managed switch a router? If not, they are 2 separate networks. A managed switch is not typically a router. yes its right, Managed Switch is not router it is in VLAN. But on SCADA PC i can go online to PLC through CX Programmer(It means it is in Network), but can not connect to PLC through kepware OPC. Share this post Link to post Share on other sites
Posted 9 May 2017 So, what is the subnet mask for the devices in the picture... Share this post Link to post Share on other sites
Posted 9 May 2017 You could have this type of issue going on: Not an EtherNet/IP error, but a FINS Node number issue as described in the link above (if subnet is other than 255.255.255.0). Share this post Link to post Share on other sites
Posted 10 May 2017 On 08/05/2017 at 7:54 PM, Michael Walsh said: What is your subnet mask? If it is 255.255.255.0 and that managed switch is not a router as Crossbow has suggested, then this will not work. 255.255.255.0 is subnet mask. Share this post Link to post Share on other sites
Posted 10 May 2017 What could be settings for shown in image Share this post Link to post Share on other sites
Posted 10 May 2017 Yes, so your basic issue comes down to the rules of ethernet. You cannot have two devices on different networks (10.11.87.80, which is on network 10.11.87 and 10.11.90.40, which is on network 10.11.90) talk to each other without a router. This just will not work due to the basic rules of ethernet networking. In other words, this is not a PLC or Omron issue, but a network setup issue. Share this post Link to post Share on other sites
Posted 10 May 2017 On 5/9/2017 at 3:50 AM, Rishikesh said: yes its right, Managed Switch is not router it is in VLAN. But on SCADA PC i can go online to PLC through CX Programmer(It means it is in Network), but can not connect to PLC through kepware OPC. The above comment that you made earlier in the thread contradicts this comment: 13 hours ago, Rishikesh said: 255.255.255.0 is subnet mask. The PLC and the PC in the drawing are NOT on the same network if your subnet mask is 255.255.255.0. Share this post Link to post Share on other sites