Weintek(Easy Builder) connection with FX3GE using ethernet

[LuDal 0]

Hello

Lopking for the way to communicate with FX3GE on Easy Builder using ethernet.

Please explain me about it.

Regards

[kaare_t 155]

Not sure what "Weintek (Easy Builder)" is, but FX3GE can use MC protocol for communication via Ethernet. Same as the other FX-series on MC protocol.

[kraykov 4]

The settings that are needed are shown in the picture

[kaare_t 155]

1 hour ago, kraykov said:

The settings that are needed are shown in the picture

 

This was only the FX side. The way I understand the question is how to setup the Weintek driver, or am I wrong?

[kraykov 4]

I'm sorry. Apparently I did not get a good idea about the question. The HMI settings are as follows:

Thank the kaare_t.

[Mortoch 2]

I have just done this about 2 months ago with an FX3U but that unit is currently on a different continent than I am. I will be returning in a couple of weeks if this is still an issue for you.