Routing table problem--can't read connected devices

1 post in this topic

I have an CJ1W-SCU31 card, in whose two serial ports are connected a grand total of 16 NS5 touchscreen. I setup the routing table with CX-Integrator and upload to CPU, then proceed to connect to each network number and download the configuration, only to be greeted by an error message stating the network configuration can't be transferred for the serial card or the communication interface. I double checked the routing table, and read Integrator manual, but can't figure out what is wrong. I tried to use the autoconfiguration function in Tools/NT Link, and it can detect all the connected touchscreen, so the configuration is correct, but still i can't get it downloaded in my PC. Suggestions?

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now