geniusintraining

Mitsubishi GX Developer 'analog addressing'

2 posts in this topic

Hello everyone, 

Looking for a little help, I have a simple project but I have not done very much analog with Mitsubishi...

Its a Q06HCPU and trying to move (MOV) my analog input to my analog output, no scaling or anything needed

(slot 1) 64AD input 1 and input 2 to my analog output (slot 2) 62DA and can not figure out the addressing... [MOV xxx xxx] would it be just this simple ?

2 inputs wired to 64AD and 2 outputs wired to 62DA, I would like to move the word or doubleword from one to another, below is the setup I have

{PS} {Q06H} {QX48Y57} {64AD} {62DA} {Ethernet} {CC LINK}

Thank you for your time 

Mark 

EDIT: I think I found the answer after searching more I will update later if it works.... http://forums.mrplc.com/index.php?/topic/15580-q-series-anolog-inout/ 

Edited by geniusintraining
More info

Share this post


Link to post
Share on other sites
20 minutes ago, geniusintraining said:

[MOV xxx xxx] would it be just this simple ?



 

 

Yes, for a double word, use DMOV xxx xxx

Edited by plcdp

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now