Posted 23 Nov 2016 Hi: I have a question on SCU21, i have a RS232 connection from SCU21 connected to a external device. how to I program CX programmer to detect connection error when the cable is removed from the remove SCU? Thanks Share this post Link to post Share on other sites
Posted 23 Nov 2016 2 hours ago, BobB said: Time out bit? I don't think there is such a bit. I had been reading the manual for the past few day. May be I overlook, do you have any idea what is the time out bit? Rgds Share this post Link to post Share on other sites
Posted 23 Nov 2016 I use protocol macro and there is a bit. Do not know about any other method. Share this post Link to post Share on other sites
Posted 24 Nov 2016 17 hours ago, BobB said: I use protocol macro and there is a bit. Do not know about any other method. Hi Bob: I used the PMCR as well, what is that Bit (A2XX)? I am reading through the manual again. Thanks Share this post Link to post Share on other sites
Posted 24 Nov 2016 On 23/11/2016 at 5:35 PM, BobB said: I use protocol macro and there is a bit. Do not know about any other method. I believe is 1518.12? Depending of unit no? I had another question, I keep getting command error, 1518.06, reception data does not agree, What is this error and how to resolve this ? Share this post Link to post Share on other sites