Sign in to follow this  
Followers 0


1 post in this topic

Just changed out a 1761 -NET-ENIW module with a new one, I addressed it with the config utility from Allen Bradley, when all is hooked up the Link and TX/RX lights are solid green. I noticed that when I addressed it , the TX/RX light was blinking, is this normal or is the TX/RX light suppose to blink while communicating ? the Ethernet cable comes in from a Ethernet switch ( MES 10/100 ) which is hooked up to a  micrologic 1400 to the 1761 - NET - ENIW then is plugged into a SLC 5/03 with a 1761-CBL-PM02 comms cable, I still don't see any change on program that is suppose to be coming over via Ethernet. any suggestions ?

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  
Followers 0