Amol Kirad

kepware mitsubishi ethernet setup

5 posts in this topic

Hello guys,

I want some solution for my Mitsubishi Application.

I am using Q03UDVCPU and I want to connect kepware server with this Q serirs PLC on Ethernet .

Is it possible ?

If yes then any extra Ethernet card required and yes the model no ? 

what are configuring steps are required to connect kepware and Q series PLC.?

 

and one more question that if I want to connect Same PLC with sato printer then which proctocol is better RS232 or Ethernet ?and also sato printer model number ?   

Share this post


Link to post
Share on other sites

Why didn't you check the kepware site. They support the built in ethernet port of the system Q

Capture.JPG

The manual for Kepware & Mitsubishi

https://www.kepware.com/en-us/products/kepserverex/drivers/mitsubishi-ethernet/documents/mitsubishi-ethernet-manual/

As for the Sato printer. I would use pre defined protocol support which is available for both RS232 as ethernet So I would probably choose ethernet so I do not need any additional hardware

Edited by Gambit
1 person likes this

Share this post


Link to post
Share on other sites

Hi thanks  for the reply.

I will check this link and again come back to you. 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now