Posted 19 Sep 2016 Hello, I am getting this fault when I am trying to load one of my program and set to run mode. I have the same plc and I have not had this problem again. 1761-L16BWA Any suggestions ? I think this plc is older than the other I have. Share this post Link to post Share on other sites
Posted 19 Sep 2016 (edited) Post the program you are trying to download. The .RSS file. Quote 0010 INCOMPATIBLE PROCESSOR The downloaded program is not configured for a micro controller. If you want to use a micro controller with the program, reconfigure your controller with your programming software (choose Edited 19 Sep 2016 by Mickey Share this post Link to post Share on other sites
Posted 19 Sep 2016 Open the EXISTING and NEW PLC programs and verify the processor in both. This screenshot notes you are using Logix Micro Lite (and you have no rung or element descriptions). Is your Logix development program a full-down license (for development and such) or a Lite license (for opening programs but not for creating new programs)? Share this post Link to post Share on other sites
Posted 19 Sep 2016 (edited) 5 minutes ago, kaiser_will said: Open the EXISTING and NEW PLC programs and verify the processor in both. This screenshot notes you are using Logix Micro Lite (and you have no rung or element descriptions). Is your Logix development program a full-down license (for development and such) or a Lite license (for opening programs but not for creating new programs)? The program posted is not the same program in the picture in post one. ??? FYI, The RSLogix Micro Starter Lite(free no license required) is fully capable of developing a new program for a ML1000 and ML1100. Edited 19 Sep 2016 by Mickey 1 person likes this Share this post Link to post Share on other sites
Posted 19 Sep 2016 I tried many programs that I have. The programs are correct! I download them on other micrologix 1000 and was running ok. Share this post Link to post Share on other sites
Posted 19 Sep 2016 (edited) 25 minutes ago, kak0s said: I tried many programs that I have. The programs are correct! I download them on other micrologix 1000 and was running ok. Double check the name plates (hardware) on both controllers. Make sure they are the same and you have selected the right controller under "Controller Properties" in the programming software. Edited 19 Sep 2016 by Mickey Share this post Link to post Share on other sites
Posted 20 Sep 2016 If you are still having problems then try changing the processor to a Micrologix 1000 in "Controller Properites" instead of MicroLogix DH485/HDSlave. Save, then download. 1 person likes this Share this post Link to post Share on other sites
Posted 20 Sep 2016 See this discussion from a while back - http://forums.mrplc.com/index.php?/topic/1270-why-do-i-get-this-fault-on-micrologix-1000/ Share this post Link to post Share on other sites
Posted 21 Sep 2016 thanks a lot for your answers! The problem solved changing the processor type from controller properties! Share this post Link to post Share on other sites
Posted 21 Sep 2016 Good to hear. And thanks for coming back with your solution. Share this post Link to post Share on other sites