Sign in to follow this  
Followers 0
syed pervez

delta dopsoft and delta PLC online simulation errors

2 posts in this topic

I am trying to communicate Delta HMI Dopsoft -W software on PC and corresponding PLC program in Delta PLC ES2 .I don't have Delta HMI at the movement.I have prepare communication cable myself. This cable communicate properly when I simulate the plc Software with delta PLC software WLPsoft. But it dosn't communicate with online simulation with Delta HMI software DOPSoft-W .but whenever Ipressed any button on PC HMI I can see the PLC communication indication LED blinking every time. I have set all the parameters of communication many time but no use.

I am using comm1,9600,even,1 and station 0 or some time station 1. but I get the communication error 7 and 10. evey time and no action.

Every time I compile my program in dopsoft it compile with no errors, and if i go for off line simulation it works fine.

I have put the correct read and write address of my used components, like X0, X1 and Y0 and data memory D400 same in DOPSoft and PLC.

could any body help in this situation.

I can also attached the image files of my PLC Ladder program and HMI program on PC later on.

Share this post


Link to post
Share on other sites
On 9/11/2016 at 11:48 PM, syed pervez said:

I am trying to communicate Delta HMI Dopsoft -W software on PC and corresponding PLC program in Delta PLC ES2 .I don't have Delta HMI at the movement.I have prepare communication cable myself. This cable communicate properly when I simulate the plc Software with delta PLC software WLPsoft. But it dosn't communicate with online simulation with Delta HMI software DOPSoft-W .but whenever Ipressed any button on PC HMI I can see the PLC communication indication LED blinking every time. I have set all the parameters of communication many time but no use.

I am using comm1,9600,even,1 and station 0 or some time station 1. but I get the communication error 7 and 10. evey time and no action.

Every time I compile my program in dopsoft it compile with no errors, and if i go for off line simulation it works fine.

I have put the correct read and write address of my used components, like X0, X1 and Y0 and data memory D400 same in DOPSoft and PLC.

could any body help in this situation.

I can also attached the image files of my PLC Ladder program and HMI program on PC later on.

hi

that was my problem too.

when you want to simulate online in DOPSOFT the ISPSOFT or WPLSOFT should not be in ONLINE mode.

 

 

Edited by Unique7220

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0