PC programming connection to QJ71E71

[Robo 1]

Can anyone point me in the direction to get a GXworks2 ethernet connection to a QJ71E71-100 module mounted with a Q03UD CPU. I have 3 HMI's connected thru a hub and all talking OK, but the PC (Windows7) refuses to connect. I can ping the module (192.168.0.10). I have tried the Mitsubishi PLC connection guide to no avail.

[Gambit 324]

Good day Mate....

Most likely you haven't setup up the network number and station number correctly. 

Check your QJ71E71 parameter setting. Most likely this is setup as network 1 and station 1.

This is fine but then in your transfer setup setup the same network number but a different station number for you PC.

On PC Side you should have Network number 1 Station No 60 (anything but 1)

Ethernet module Network Number 1 station number 1 (The same as setup in your network parameters)

 

Edited 23 Aug 2016 by Gambit

[Robo 1]

You were spot on. Always the simple answer. Thanks very much. I don't understand why others here missed this as well. My sanity has been restored.