Mitsu FX2N & GT1030 comms cable

[Lars F 2]

Hi,

I have successfully converted F940Got HMI software to GT1000

and since the conn. to the plc was the same 9-pin dsub as on the original HMI

it all worked fine.

Now I have converted F930Got (smaller HMI) to GT1030

but the plc comms connector is different (terminal strip instead of 9-pin dsub)

and I cannot figure out how to  wire an adapter between the 9-pin dsub  (on original plc to got930 cable)

and the 9-way terminal strip.

A signal pinout of the FX2N round 8-way connector would be a good start

or

is there a ready made connection cable with pinout somewhere on net?

(FX2N-30MR to GT1030)

 

Lars

[Akahige 25]

Try this startup guide for the 1020/1030 to FX. Diagrams from pages 3-7. Sorry, not familiar with the 930 enough to give you a comparison chart. Hope it helps though.

GOT1030 to FX connection.pdf

[Akahige 25]

Ah yes...try this as well. The SC-09 is the connection cable for the A series and FX serial RS422 ports.

[Lars F 2]

Yeah, the SC09 cable drawing solved the problem

GT1030 HMI now talking to plc and shows the converted program

THANK YOU VERY MUCH

Lars

[Cagey93 0]

hi, may sound simple but I am struggling to connect my got GT1030-HBD2 to an fx3s plc.

After much digging, I have found that my got screen has RS232 format connection strip and the plc is 422 format.

I think I need an RS232 to RS422 converter? 

The terminal strip on GOT screen has markings : SD,RD,ER,DR,SG,RS,CS,NC,NC.

Can anybody help?

Regards,

Philip