Sign in to follow this  
Followers 0
machinebuilder

1761-net-eni

2 posts in this topic

the 1761 is a ser D. i configured the module. Is it possible using ethernet through the device to access address specifically map to and from the B-bits, or N-interger? Or is the ENI module only used for programming? If I can access address through the ethernet port, what literature would explain that? I followed the ENI configuration program and it only allowed me to set the baud rate, IP address, etc and showed me how to configure the PLC. But nothing is said about mapping.

Share this post


Link to post
Share on other sites

the ENI is strickly a communication module. It does not do any internal mapping

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0