Budianto

OMRON NT3S-ST124B-E NTXS V1.03 n V1.04

7 posts in this topic

Dear all,

Does anyone have a NTXS verion 1.03? I can only find ver 1.04 in the internet.

I am having a trouble while replacing NT3S-ST124B-E. The old one is using RS422 Communication. using a 5 cable in pin 1, 4,5,8, and 9. But it can not communicate after i download the old program I uploaded(firmware ver 1.03) to the new unit (firmware ver 1.04). it keep saying com 1 Communication Error.  From the manual NTXS software, I discovered that the communication driver supposed to be downloaded together with the firmware.

 

I used this cable RS-232 connection for programming (upload /download) and it works perfectly fine:

db 9 Male (NT3S-ST124B-E) to db 9 female (PC)

2 to 2

3 to 3

5,9 jumper to 5

 

The program i managed to upload using NTXS 1.04 in Win 7 32 bit and sucessfully download to the new NT3S in Win XP 32 bit (tried so many times but it fails on Win 7 32 bit). The program says that the NT3S is connected to CJ1 PLC.

The cable used to connect to the old NT3S is using Pin 1,4,5,8,9 which means it should be RS422 (Xtra Drive).

I wanted to try using version 1.03 but I can not find it.

 

Regards,

Budianto

Scanner NT3S.pzm

Share this post


Link to post
Share on other sites

NT3S

Edited by Jay Anthony
Sorry. Wrong version.

Share this post


Link to post
Share on other sites

Courtesy PDL:

 

NTXS_1.03.zip

1 person likes this

Share this post


Link to post
Share on other sites

Could you please provide the firmware for NT3S-ST124B-E?

My equipment says that I need to download the firmware, but i can't find it.

Thanks in advance

Edited by PLCforall

Share this post


Link to post
Share on other sites

The product was private labeled by Omron from Renu Electronics.  If you have lost the firmware, you will need to contact Renu Electronics.

http://www.renuelectronics.com

 

Share this post


Link to post
Share on other sites

i need firmware for NT3S-S126B-E

thank

Edited by Parviz

Share this post


Link to post
Share on other sites
On 15.11.2018 at 6:55 PM, PLCforall said:

Could you please provide the firmware for NT3S-ST124B-E?

My equipment says that I need to download the firmware, but i can't find it.

Thanks in advance

 

On 16.06.2019 at 4:48 PM, Parviz said:

i need firmware for NT3S-S126B-E

thank

If you run NTXS As administrator, the firmware will download to HMI without errors.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now