Sign in to follow this  
Followers 0
kingkumak

Sysmac Studio, MX2 inventer,

2 posts in this topic

Hello eveyone, 

I connect via Ethercat the MX2 inventer to NJ301. I want to my engine works with very low frequency (10Hz for example). I configured inventer to works in Ethercat, but everytime when I send to inventer commend RUN, it increases frequency to 50Hz. I wrote to inventer command frequency reference for example 10Hz, next set command RUN to 1 and inventer always goes to 50Hz. 

Do you have any ideas how to fix this problem?

Share this post


Link to post
Share on other sites

Check A001.  It is the frequency reference selection.  I believe that it should be set to 4.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0