Posted 12 May 2016 I am having trouble loading the configuration into a Micro984-230. I lost an old M84-002 PLC. I have the program. I purchased a Micro994-230 replacement. I lost my cable, so I made a new one. The only software that I have still running is Updoc 4.30b. I tested out my cable and Updoc by connecting to a 984-381. Everything worked fine online and offline. The error I get during the configuration loading is communication error 13. I have no idea what that is. Perhaps I can't do configuration loading with Updoc. I have Modsoft Lite working but I do not think that it works with this controller. It is for MIcro and Compact controllers. I may have modsoft and taylor kicking around but I do not know if they are installable or not. I hope I can find out if my config is improper, I have used the wrong controller setup file (used Micro984), or where iI can have the config loaded for me? I also do not know if this used controller is functioning correctly. Share this post Link to post Share on other sites
