vivek

how to regain running process after power failure

5 posts in this topic

how to regain running process after power failure fx 3u plc

Share this post


Link to post
Share on other sites

Hi Vivek,

You could use retentive markers, D-words and timers/counters to keep the state of your proces in the memory. See te hardware manual for the exact details. As an example: the retentive range of Markers start at M384.

Best regards,

Theo V.

Share this post


Link to post
Share on other sites
19 hours ago, Theo V said:

Hi Vivek,

You could use retentive markers, D-words and timers/counters to keep the state of your proces in the memory. See te hardware manual for the exact details. As an example: the retentive range of Markers start at M384.

Best regards,

Theo V.

And as a small side not to @Theo V's good answer, Markers (and D-words) can be adjusted to start at 0 (instead of e.g. M384)

Share this post


Link to post
Share on other sites

Hi Myanmar,

See the attached Word document for a small example of a retentive drivemotor of a conveyorbelt with start/stop.

I hope this is clear enough. I had some trouble coping from GX developer so it looks a little poor sorry for that. (the result is what matters)

 

Best regards,

Theo V.

Example retentive marker in a FX1S PLC.doc

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now