Momentum Unity Processor

[brewer 0]

I am having issues with a unity processor.  I have converted the Proworks32 program to unity and for the most part the system is running fine.  My processor is in the electrical room and the I/o is distributed throughout the plant on I/O bus.  Every so often some outputs drop out stopping my conveyors. The start button is pushed and the system start right back up.  Is there any diagnostic information I can get from Unity to help resolve this issue?

[Quant 21]

Hello brewer, unfortunately it's not enough info to help you. Are you using - I/O (interbus) and the bus was not changed and only aplication was converted to unity and plc was replaced? Then maybe it make sence to check the firmware update for the momentum plc?