Sign in to follow this  
Followers 0
dedshaw1612

Using a message instruction to Send Email

2 posts in this topic

I am having issues trying to send an email using the message instruction and the ENBT module. Attached are snippets of my configuration of my message instruction and the error code that i am getting. I had IT look into it on their side and i shouldn't have any network switch configurations that is blocking the successful delivery of the message. Anyone have any ideas what could be the issue?

Thanks!

email1.JPG

email2.JPG

Share this post


Link to post
Share on other sites

Also as a note it doesn't fail immediately when i activate the instruction. It is enabled for probably 15 to 20 or so seconds before it throws the error.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0