manisha

Graphic Operational Controller

6 posts in this topic

Please give me the steps how to communicate GOC with Laptop using Ethernet and serial port

I have using Codesys for Programming

1 person likes this

Share this post


Link to post
Share on other sites

I see that the GOC is a purely Indian product developed by Mitsubishi in/for the Indian market. I have never seen or used a GOC before and since it's only for the Indian market I think it may be difficult to get help in this forum which is quite international. Please do try, I'm just giving you a small "heads-up".

Share this post


Link to post
Share on other sites

Get the help form Mitsubishi electric India

Pune,maharashtra.

They know it very well.

Share this post


Link to post
Share on other sites

Hello all, I too have the same doubt on communicating goc 35 with codesys via ethernet. If any found the solution please do share here!

 

Share this post


Link to post
Share on other sites

pls start the goc35 by giving supply 

next connect your laptop to goc by ethernet. then you wont get any ip address on it 

next you switch off whole goc 35 supply

then leave some 2min 

next switch on the goc35 you will get ip address ,gatway, ....etc

then you go to and set ip address in your laptop in codesys software in communication paremeter the local host address 

only chang the last three numbers

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now