Sign in to follow this  
Followers 0
Wish177

PLC siemens 300 with wind monitor

2 posts in this topic

Hi there!

Can someone please tell me where I should put the wind monitor wires at PLC? I have been trying for days to find out.

I have the model 05103L http://www.youngusa.com/Manuals/05103L-90(I).pdf Take a look at page 5 at the dokument. I believe 3 and 4 are suppose to be connected to the PLC, but I dont know where.

I have PLC300 siemens with AI 8 x 13 BIT (331-1KF02-0ab0) and A0 2 x 12 BIT (332-5HB01-0AB0)

I know its suppose to be in AI, but I dont know where at AI.

here are a dokument for PLC 300 siemens.

https://cache.industry.siemens.com/dl/files/629/8859629/att_55794/v1/s7300_module_data_manual_en-US_en-US.pdf

Please help, I have been stuck on this for days.

Share this post


Link to post
Share on other sites

wire +24 vdc to the black and white wires of the wind speed instrument (WS+, WD+)

wire the red wire to the AI module CH0 I+ terminal (2) wind speed (WS-)

wire the green wire to the AI module CH1 I+ terminal (7) wind direction (WD-)

wire -24 vdc to AI module CH0 + CH1 M- terminals (5,10)

go to hardware config and make sure the analog card CH0, CH1 are set to Current 4-20. I've attached a picture of how your analog card should be configured in HW Config.

Good Luck.

analogsetup.JPG

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0