srob.tl93

How to create an user name and password to open a screen?

12 posts in this topic

I use GT Designer 3 for Got 2000. And I want to create an user name and password to open a screen that i cant adjust the important value.

Share this post


Link to post
Share on other sites
Attached an example for a GT15. But it should be the same for GT2000. passwords: 1:1234 2:4567 3:7890 Password_Access_Denied.zip
2 people like this

Share this post


Link to post
Share on other sites

 

On 13/11/2015 at 4:18 PM, Gambit said:

Attached an example for a GT15. But it should be the same for GT2000. passwords: 1:1234 2:4567 3:7890 Password_Access_Denied.zip

Hi Gambit

Could you reupload this file for me. I need your file to refer.

Thank you so much.

Edited by minhpham

Share this post


Link to post
Share on other sites
On 1/18/2016 at 2:48 PM, Gambit said:

 

On 11/13/2015 at 4:18 PM, Gambit said:

Attached an example for a GT15. But it should be the same for GT2000. passwords: 1:1234 2:4567 3:7890 Password_Access_Denied.zip

Hi Gambit

Are you sure your passwords? when i simulator your example and enter your passwords

but GT warning passwords error

please help me recheck your passwords

Thanks you so much Gambit

 

Share this post


Link to post
Share on other sites

If you want to clear the password just got to the security settings

Set this to none then press apply

Set back to Password with GD200 as the device and press apply

and set some new passwords

 

 

 

Edited by Gambit

Share this post


Link to post
Share on other sites

Hi everyone! I can't start security function to visible/act my buttons etc. I have 2 levels 2 and 3 with passwords, but it do not effect. Simulator is OK, but real GT16 do not work! Is there any function I must write to panel? OS ver. 05.54.00. Tq.

Share this post


Link to post
Share on other sites

The security function writes the current level to a register.  Make sure your PLC program is not writing over it.

Share this post


Link to post
Share on other sites

I just want to use security (no user) at runtime. But when I wrote "operator authentication" module to panel - this feature stopped working! Cannot delete the module files from panel. How to factory defaults?? How to use reset button??

Edited by eziccc

Share this post


Link to post
Share on other sites

Solved! Pres button S.MODE in the back of panel - power on! OS and project are clear now..

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now