Posted 17 Oct 2015 Here's what I'm trying to do. when switch closes turn on output for 1 scan, starts a 10 minute time and counter, so that when time reaches 10 minute it will turn on output again for 1 scan and count another count, timer resets and counts another 10 minutes and turns output on again for 1 scan, and count another count when count gets to 5 this process is complete. I can do this in RSlogix500 with a micrologix 1100 but can't seem to get it working with the Micro800 and connected component workbench. Share this post Link to post Share on other sites
Posted 18 Oct 2015 So what part is not working for you? And what is your current program? Share this post Link to post Share on other sites
Posted 18 Oct 2015 I think I have this figured out. I need to use the "R_Trig" instruction. This is the same as a ONE-SHOT in RSLogix500 for the Micrologix series PLC. The "R_Trig" instruction will only be TRUE with a Rising Edge Input and only for the "Rising Edge" (Thus 1 scan). I'm new and do not totally understand all of the instructions that "Connected Component Workbench" has to offer yet. I will correct program today and post results, so everyone can benefit from my inexperience. Share this post Link to post Share on other sites