Posted 5 Jul 2015 (edited) Hi, I'm trying to set up communication between a cj2m plc and an indra drive servo driver from bosch rexroth over ethernet/ip. Tried following a youtube video from rexroth explaining how simple this drive is to set-up with a 3rd party plc.... I have no experience with ethernet/ip, but what the video describes, i can't seem to do with omrons network configurator. more specific info on my equipment. Indra drive: HCS01.1E-W0013-A-02-B-ET-EC-NN-NN-NN-FW Firmware: FWA-INDRV*-MPB-17VRS-D5-1-NNN-NN PLC: CJ2M-Cpu31. rexroth info says there is no eds file for this firmware, i have to use a generic ethernet module, and set up from there. I've tried everything i can think of and implemented all googled info i've got to no effect, can't get communication. Any help getting this drive running is very appreciated. Thanks, Frank Edited 5 Jul 2015 by FrankA Share this post Link to post Share on other sites
Posted 6 Jul 2015 Attached is a pdf with pictures of various settings for the ethernip/ip connetion, hoping that someone will spot a simple error... Dokument1.pdf Share this post Link to post Share on other sites