Posted 18 Nov 2014 hello my project is to communicate a master 90-30 with port IC67CMM711 and a slave 90-70 with cpu IC693CPU374 using SNP Service BUT CUMMUNICATION IS FAILED; THE ADDRESS state of attachment returns 16#040C THAT MEETS IN THE MANUAL: SLAVE Equipment SNP Did not respond to the message sent by the master i jave joined my configuration hardware of master and slave Share this post Link to post Share on other sites
Posted 18 Nov 2014 The problem could be in the cable connecting the two PLCs or it could be in the setup of the COMMREQ instruction in the 90-70 that initiates each exchange of data between them. Please provide details of both. Share this post Link to post Share on other sites
Posted 18 Nov 2014 There is another possability here: http://forums.ge-ip.com/showthread.php?t=19685 Share this post Link to post Share on other sites
Posted 19 Nov 2014 yes i have wrote this publication :) Share this post Link to post Share on other sites