VersaPro - Check for Overrides?

[Chris Elston 78]

Is there anyway in VersaPro software to check or scan for overrides that have been set in the PLC? Sometimes I set an override and forget to go back and release it. It would be good if VersaPro would tell you if there are some that still exist or if there is a way to release them all. Any pointers?

[Steve Bailey 118]

The status bit %S0011 (OVR_PRE) is on whenever an override is active. In addition there is Service Request #18, but that only checks the %I and %Q tables for overrides. Unfortunately, there is no blanket "Clear all overrides" command.

[Chris Elston 78]

Kewl. Atleast I can write an alarm or something to prompt me that I've done so. Thanks Steve.

[glaverty 1]

Under the PLC menu there is also a search for overrides command.

[Chris Elston 78]

Wow...I must be blind as a bat. It's right there where you said. That will work like a champ!