Posted 11 Jan 2013 So, I have a MicroView key pad. CAT# 2707-MVP232, SER A REV A that my boss purchased off of Ebay a couple of years ago as an emergency spare to our brand new in box spare. Earlier this week we wanted to use the Ebay unit for a test with a MicroLogix 1000. Boss built the MicroView program and was trying to download it and ran into some problems. When programming a MicroView you have to tell it that it is in programming mode before you download a program in to it. Problem is when you press the mode button to access the area in the MicroView to tell it to go to program mode it asks you for a password. Is there a way to clear the MicroView or get to the programming mode with out the requested password? Share this post Link to post Share on other sites