need technical support

[Mahmoud Abd El-Hameed 0]

URGENT I have omron servo motor connected to mcw 151 motion card, it is working OK . card is damaged so we change with new-card, we upload program from old card , check in other machine program is OK , we get the new card , install it ( not working .. download program to new drive ... not working also , try on other machine , not working ..) we remove old card from other machine try at stopped machine it worked OK. also delete old program from working card an re-download to it again .. working OK. so we decide to change the motion card with new one >> but some one change the parameter of the servo so if i get new card what parameters i should set to work with motion-card and also if i only download the program to new card machine will work or some data must be set in first. regards

[Walid Elshazly 1]

You need to replace this card by new one , and ask Mr:Walid to help you in programming this new card . :slydog: Regards Edited 10 Jul 2011 by Walid Elshazly

[Jay Anthony 118]

Start off by reading the manual... I203-E2-02 MCW151 Option Board @ MrPLC.com