Question about buttons (FactoryTalk VS ME )

[CanaanP 1]

I know this may seem some what remedial, but I am wondering can I dismiss a popup window when operator presses a momentary button that writes a value to PLC? This is a simple confirmation popup that I have posted about recently, containing a reset button and a cancel button. I would like reset button on confirmation popup to reset but also dismiss the popup at the same time. Is this possible? I have tried overlapping a display return or display close button on top of my reset button but it is not effective.

[JRoss 84]

You can do that using the Close Display button. On the "General" tab in the "Value" section, check "Write on close" and put your chosen value in the "Close value:" box. Then set a tag up on the "Connections" tab, and you're good to go. I know you can do this with version 5 and up. I haven't tried it with older versions.

[CanaanP 1]

Thank you, that does the trick :) I don't know why I didn't look a little closer at those properties, thanks again!