Sign in to follow this  
Followers 0
pr2501

m8002

Started by pr2501,

4 posts in this topic

Posted

I use M8002 To drive the setting of the initial state. What should i use to do alike after PLC was put in stop mode and turnet back to run?

Share this post

Link to post
Share on other sites

Posted

M8002 turns on for one scan after PLC is put from STOP to RUN.

Share this post

Link to post
Share on other sites

Posted

M8003 is the NC version of M8002 m8002.bmp

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0
Go To Topic Listing Mitsubishi