Posted 18 Sep 2008 I am new to this, I have CPM2A PLC connected to a MAD01, i would like to configure this in CX-One, but during setting up of new project i cannot see I/O list so that i can configure the MAD01 module? TO the MAD01 I have connected a ultrasonic sensor which outputs voltage at different levels. Please Help. Share this post Link to post Share on other sites
Posted 18 Sep 2008 Hi and welcome to MrPLC.com! The CPM series expansion units do not support configuration through CX-One or CX-Programmer and have to be configured by setting register values with logic instructions. Have a look at section 3-1-1 of this manual: CPM1/CPM1A/CPM2A/CPM2C/SRM1 (-V2) Programmable Controller Programming Manual Hope this helps! Share this post Link to post Share on other sites
Posted 16 Apr 2016 Hello i am having same issue, its been over 8 years i didnt touch my plc, i totally forgot how to program my cpm2a and all the tutorial i find dont seem to reflect what i see so i feel like in a dead end, can anyone help? Share this post Link to post Share on other sites
Posted 16 Apr 2016 Quote Hello i am having same issue, What's the issue? Share this post Link to post Share on other sites