CX One Simulator Problem

[MarkoSavic 0]

I have CX One ver. 3.0 installed on my computer. One month after installation, I lose the "Start PLC-PT Integrated Simulation" button (it goes gray) in both CX Programmer and CX Designer and there for cannot start the simulation. Then I simply repeat the installation of CX Simulator and the button again works normally for another month or so, when I need to do it all over again. Does anyone have similar experiences?

[PdL 71]

Using a registry cleaner perhaps ? CX-Simulator disabled from within CX-Programmer ?

[Automation 1]

It is very strange. I know CX-One Trial. To the 30 days it no longer allows to execute anything. Alone it can settle again after a "good cleaning". It proves of upgrading CX-One through the web: CX-One Auto Update You should be registered. If you are not able to it is that your license has some problem.

[MarkoSavic 0]

Thanks PdL, it was problem in registry. I've added missing lines in registry and Simulator works again!

[PdL 71]

You might want to check if your registry cleaner (if you use one) also checks for invalid application paths. Mine did and since I disabled that check it doesn't happen again.

[BITS N BYTES 66]

http://forums.mrplc.com/index.php?showtopic=14095 http://forums.mrplc.com/index.php?showtopic=11917&hl= This fixed my similar problem with CX Simulator. Edited 24 Jun 2008 by BITS N BYTES