Posted 20 May 2008 Dear All, I am using CJ1W AD041 unit, and have some problem with offset, in manual W345-E1-05 i found the way to do an adjustment by using handheld programmer which i don't have now and it seems complicated. Does anybody has information how to do it by CX programmer? Thanks in advance. ahuat Share this post Link to post Share on other sites
Posted 20 May 2008 Did you have a look at the unit's parameters setup in the IO Table? Share this post Link to post Share on other sites
Posted 21 May 2008 My mistake, I missed the part where you mentioned offset To be honest, never had to do that. But if I have a quick glance at the manual: You can follow the procedures as described per manual section 5-7, but instead of entering the data with the handheld, I suggest you enter the CIO words to modify in the watch list of CX-Programmer. To make it easier, you could add the boolean symbols to the symbol list so you can identify them easily in the watch list. Alternatively, you can assign a keyboard combination to the PLC:Set on / Set off commands, to quickly turn the bits on or off when adjusting the offsets. It will probably require some practice though... Share this post Link to post Share on other sites