E1000 Panel audible alarm

[roger10 0]

Hi, I'd like to have an audible alarm when the bell, for the alarm indication, in the top right corner occures. I checked the E-Designer helpfile and found the Buzzer register (in the System Signals directory). Does somebody has experiences in using the buzzer register and how do I configure this function? Thanks for your help.

[tragically1969 0]

I would personally use the active signal under alarm properties (just choose which M coil you want to attach it to) this will be active as long as an alarm is active on the HMI, see manual page attached.

[Crossbow 295]

You can set the buzzer signal to a PLC address and then use that address to drive an audible signal. The basic method is shown by tragically1969 in his post.

[roger10 0]

Thanks for your help. I already tried it and it works fine.