Sign in to follow this  
Followers 0
Critt

Q02HCPU CC-link problems

4 posts in this topic

Hello, I have a Q02HCPU with a QJ61BT11N Module in slot 9(0-9) which will communicate over cc-link cable to 5 remote I/O stations AJ65SBTB1-32D-U. I am not sure how to address these remote stations and the cc link master. Any help would be great.

Share this post


Link to post
Share on other sites
First things first have you got the network running ?? All L-Run LED's burning?? aftre that just fill in the start adress for your Bit input Remote input(RX) You have 32 input modules so all inputs should count from there. RX = M1001 module 1 M1001 - M1032 module 2 M1033 - M1064 module 3 M1065 - M1092 ... Edited by Gambit

Share this post


Link to post
Share on other sites
The first thing that matters is the modules in the rack in front of the CC-Link card. The head address of the CC-Link card will be important in order to configure the PLC network parameters for the CC-Link. What other modules are installed in the rack?

Share this post


Link to post
Share on other sites
Maybe this example helps... Configuring_CC_Link.pdf

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0