Search the Community

Showing results for tags 'wago'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Found 5 results

  1. Omron CJ2M - Wago remote I/O

    Hi there, I’m not sure how familiar most of you are with Wago remote I/O, but I hope you may have some solution for the following connection problem I’m having. I’m working on a project to modernise an old folder collecting machine for which I’m using an Omron CJ2M Cpu33 together with 8 Wago 750-352 remote I/O units over ethernet/ip. These Wago units all contain two 8DI digital input cards and two 8DO digital output cards alongside a 750-610 bus power supply card. Adding them to my network in CX network manager is no problem and all seems to work fine. That is, as long as I don’t physically add the bus power supply card, which I need to, well.. power the Wago bus. Soon as I add this card (which was in place while making all the necessary settings to the Wago and Omron units) it just won’t connect. Remove it and it connects like it should. As far as I know the power supply card has no I/O addresses or other communication functions whatsoever, so I can’t get my head around it. Even stranger is that when instead of it I add an analog input card, with bus power connections build in, it connects without a problem. The .eds file only contains info about the main Wago unit, after installing it I should be able to add any kind of I/O card and address them in the Omron software. Also, the supply card is added and visible as a fifth card in the Wago I/O settings and the I/O status led is green during this error. Therefore I would say the problem is at the Omron side. Any sugestions?   Thanks in advance Andy - The Netherlands  
  2. Hi All  I'm struggling to a PLC using WAGO's e!cockpit software which I am new to.  In the network tab when I click to select "ETHERNET" from the "Scan Settings" area all that comes up is a drop down with "update selection" which does nothing.  As a result I cannot scan for the PLC's on my network. Has anyone got any ideas on this issue.  I'm running on windows 10, could that be a problem?     
  3. Hi Everyone I am using Wago 750-8203 PLC with an Atlas Copco MKIV local controller in my project. In this project I have used WagoCANLayer2_02.lib because the project requires me to use CAN Open protocol. I attach the function block diagram to read data from the local controller by sending the required CAN data. When I run the program it shows CAN_ BUS_IDLE error. I have given the right CAN_ID and data, I did not understand, Why  I am getting this error. So please can anyone help me. Thank in advance for the help.
  4. Hello all, I'm working on existing project with Citect scada V6.0. My actual HMI communicate with my TSX P57 threw OFS. It works fine. I've a new project about linking Citect with 1 Wago PLC, using modnet. I've created a new project for that, out of my actual project. It's working fine too. I can read all the modbus TCP datas of my wago Unit.  My problem is now integrating my wago project into the actual. I include it into, but it does not work. To resume, If i use the only actual project, I can watch my data on the screen threw OFS; I i use the modnet project alone (after configuring the citect computer setup), i can wath my wago data on the screen. If I use the both project together, (including modnet project in the actual), modnet data are not linked. Any ideas to help me? thks all
  5. Hi. My goal is to communicate from a Wago 750-881 Controller to CJ2M With ETN21 on Modbus UDP. I can only find Modbus TCP function Blocks but would prefer UDP. Does it excist ? Cheers. WagoGrim