Search the Community
Showing results for tags 'topology'.
Found 5 results
-
Hello all, I am looking into creating a system where I have an NX102 in a main panel, and numerous satellite panels (up to 20) with EtherCat Slaves which would then have daisy-chained EtherCat slaves. Essentially, the main panel would need a GX-JC06 to allow branching out, but this only has 6 ports. 1 of them would be used to connect to the master (NX102), but would I be able to connect one GX-JC06 to another? I highly doubt the GX-JC06 behaves like a typical router, but I can't find any documentation about creating more than 5 branches. Thanks, K
-
Hi all, i am looking for a solution to connect 7 plc with a single scada. is it possible according to my topology diagram ? Kindly make me suggestion and if you have any information regarding the solution then share . Thanks in advance.
-
Ethernet/IP bus line topology to ring.
Jiggadoo posted a topic in Allen Bradley / Rockwell Automation
I have an Ethernet/IP bus and system including Ethernet/IP devices with CPU 1756-L81ES ControlLogix. PLC is connected to the switch. Bus is built from the switch as a line. Can I connect the last device on the bus back to switch again? In thes case bus will be ring. Do I get problems with connection it this way. Switch is Stratix 2500, which is lightly managed switch. I believe it will increase the traffic in the bus.- 3 replies
-
- ethernet/ip
- line topolygy
-
(and 1 more)
Tagged with:
-
Hello all, i'm looking at installing a completely new network for our PLC system, using a ring topology. at the same time i would like to incorporate the IP cameras and VOIP into the same network. each system is on a different sub net, PLC = x.x.1.x, Cameras= x.x.2.x, VOIP= x.x.3.x estimated camera traffic will be 25 Mbps, PLC 10 Mbps, VOIP no more than 1 Mbps switches would be capable of 100 Mbps question: managed or un-managed switches? if it is possible to use un-managed without affecting operations then this would be a massive cost saving please only comment if you have practical experience implementing this many thanks Dan