Search the Community

Showing results for tags 'prm21'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Found 2 results

  1. Hi again. I'm trying to make profibus connection between CJ2M and "Bosch Rexroth HF03 Manifold 12 Station DeviceNet Bus Box". After configuration I/O table in cx-Programmer and up[loading it to plc I've tried to configure settings in CX-Configurator. I've set up correct connection parameters of cj1w-prm profibus master. When I use "Test" option or just go online I get errors: "Communication Failure with unit" and "CX-server cound not be initialized". Am I missing CX-Server? I don't have this software installed on pc... When i try to use scan option i get another error: "Scanning failed, DTM returned an error for the request. Following DTM reported the error: Tag: CJ1W-PRM21 PROFIBUS Master Name:CJ1W-PRM21 PROFIBUS Master (Version V1.xx) Vendor OMRON Corporation.: Any advices? I can't find any good manual for CX-Configurator but i get CX-Profibus manual - is it interchangeable? Because i can see  some same options in both. Regards!  
  2. CS1G-H CPU42 with CS1W-PRM21 problem

    Hello everybody, I have a problem connecting CS1G-H CPU42 with CS1W-PRM21. Prm21 is inserted in slot 9, and i have previously made connection to prm21. After downloading configuration to prm21 i cant connect to prm21 anymore (connection to plc is working fine). The cx-configurator says CS1W-PRM21 PROFIBUS DP-V1 Master Communication Failure with UnitERH is on (red), BF is flashing red, RUN is on (green), PRM is on (green) and BST is flashing green. How can i restore comunication with the cs1w-prm21 to diagnose the problem? After some examination the problem is (probably) that i have configured prm21 to write in the adresses of CIO3000 to CIO3400. That is interfiering with other address. Is there any way to force the output of the prm21 off, or make device go in offline mode.At the power on of the prm21, i can test the connection via cx-configurator and is working and after 2 seconds the prm21 goes to stop mode and begin writing to address of the sysmac bus area. I am thinking if i can stop prm21 from writing to that area i will be able to connect and load default configuration.is that any way to stop the prm21 from automatic start? or is there a way to reset prm21 to factory settings? best regards