Search the Community

Showing results for tags 'invalid'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Found 5 results

  1. CX-supervisor

    I want to send data from internet to cx-supervisor via cx-supervisor website but error. i don't know how to resolve this problem .I attach photo below, people help me with
  2. hi guys, i want to ask about cx supervisor development 3.0. i have problem with my cx supervisor. my cx-supervisor cant run, but can built succesfully. my cx supervisor 3.0 development version, my cx supervisor problem like this. do you have solution ?thx for attention,sorry for bad english best regards
  3. Hello,    I have a Cognex insight 5100 camera connected to Allen Bradley L62 processor. The is working fine since the last year but sometimes the I/O module faults out with error code 16#0022. I looked online it look it needed a Ethernet cable change ( I did that but no results).  Then I looked at the firmware in the I/O module and firmware in the camera and I found a difference. The firmware in the camera is 4.06 and the firmware of I/O module in the PLC is 4.005. Can anyone help me resolve the communication issue ? I want to know how to downgrade the camera firmware or change the revision in the PLC ( which I cannot )    Thanks in Advance 
  4. Hello,    I have a Cognex insight 5100 camera connected to Allen Bradley L62 processor. The is working fine since the last year but sometimes the I/O module faults out with error code 16#0022. I looked online it look it needed a Ethernet cable change ( I did that but no results).  Then I looked at the firmware in the I/O module and firmware in the camera and I found a difference. The firmware in the camera is 4.06 and the firmware of I/O module in the PLC is 4.005. Can anyone help me resolve the communication issue ? I want to know how to downgrade the camera firmware or change the revision in the PLC ( which I cannot )    Thanks in Advance 
  5. Hello A-B Guru's, I have a small station with a Micrologix 1000 controller in it. Keep getting a "Major Halt Error S:1/13, Invalid STI interrupt set point. Refer to S:30." It is a very simple program, not using the STI instruction. Have a filter on the processor power. Nothing crazy going on, on the station, no big coils, etc. What can I do to prevent this fault from occurring? Can I add a line of code to always unlatch S:30? What should I do? Please help.