Search the Community
Showing results for tags 'fuji'.
Found 4 results
Hi All, I am doing an application that use servo motor to feed plastic film to a target length (set by operator), and it need to stop immediately if marker sensor is ON. This application is control by Omron CP1E PLC. It will feed plastic film in 500-1000mm/s depends on the target length set by operator. It is require to stop immediately if the servo feed length more than 90% of the target length and the marker sensor is ON. However, is there any possibility for the servo to stop immediately once the condition is meet? As I am using PLS2(887) to feed with target length, and INI(880) to stop immediately, however, it cannot get the desired result as servo not able to stop immediately after marker sensor is ON, I am not sure is because of the PLC scan time, or servo need time to deceleration (deceleration rate assigned to #FFFF). Appreciate anyone able to assist on this. Thank you.
Hello, everyone. I want to ask for help.. i want to upgrade HMI hakko V7 to V9.. have file hmi in V7 use software V-SFTV5 but when I open file V7 use software V-SFTV6 its cant convert and i attached the screenshoot below.. can someone tell me what's wrong?
Hello! Anyone here know about Fuji Electric power monitoring unit F-MPC04? Does anyone have the Communication Manual for this unit? I need to find the F-MPC Protocol which it used with RS-485. I know it is accessible via MODBUS RTU, but there is already a system exist using this F-MPC protocol. It seems Fuji doesn't publish this protocol for public, but there should be a document somewhere :D If anyone knows please kindly reply here. Thank you
Hi everyone, I have a Problem with PLC Fuji: Micrex-Sx series (SPH300) control servo FLADIC Alpha system (fuji) through SX-Bus. I don't now I/O assigned off servo FLADIC amplifier through sx-bus, how to control motor run. Anyone have experience with this help me, Please! Thanks so much!