Search the Community
Showing results for tags 'ethernetip'.
Found 3 results
Hello, I am trying to connect a Weidmüller UR20 Ethernet I/P (Hardware version 1) to a Omron NX1P2 PLC via Sysmac Studio. I have imported the Weidmüller EDS file into Sysmac studio and connected two tags to the target variable 101 and 102 (I also tried using a array of bytes and a single word). When I transfer this configuration to the controller and set the controller in run i get the following error: Tag Data Link Connection Failed (0x84070000). I have tried to update the firmware of the Weidmüller I/O but this doesn't seem to help. Also the web interface shows no connection with the PLC. I also tried to setup the connection with the CX network configurator but this gave the same result. Is there someone who can help me with this problem Thanks in advance.
TigerLily posted a topic in CX-DesignerI have an existing project that I have used the smart active parts for (and they worked great), I copied this existing project to create a new one but the communications changed from Serial to Ethernet IP...so I used the replace host feature to convert the serial comms to Ethernet IP, now I am not able to get the SAPs working, I edited all of the destination network and node addresses but only the CPU Unit Status display cycle time and clock information appear to be working. Do they not work correctly over Ethernet IP or am I missing something? I was not able to find very much on setting up Ethernet communications with the smart active parts so I don't want to spend a lot of time on it if it is not possible... Thank you!!
TigerLily posted a topic in OmronI need some help and advice communicating between an Omron PLC and a Keyence KV-5500. My system typically uses an Omron CJ2M-CPU34 which comes equipped with the built in Ethernet IP port. My customer is insisting that we change the CPU in our system to a CJ2H-CPU66-EIP in order to communicate with the Keyence KV-5500. They have not been able to detail why their communications require the CJ2H, they just say they will be using Ethernet TAG communication and for this they need us to change the CPU. Has anyone successfully established communicated between the Omron PLCs and the Keyence? If so how did you do it and which CPU did you use? Is there an .eds file available for the Keyence CPU? Please help!!! They will be visiting from halfway around the globe to test communications in January so I want to be prepared!