Search the Community
Showing results for tags 'Subnet mask'.
Found 3 results
Hello all, i'm looking at installing a completely new network for our PLC system, using a ring topology. at the same time i would like to incorporate the IP cameras and VOIP into the same network. each system is on a different sub net, PLC = x.x.1.x, Cameras= x.x.2.x, VOIP= x.x.3.x estimated camera traffic will be 25 Mbps, PLC 10 Mbps, VOIP no more than 1 Mbps switches would be capable of 100 Mbps question: managed or un-managed switches? if it is possible to use un-managed without affecting operations then this would be a massive cost saving please only comment if you have practical experience implementing this many thanks Dan
I have restored a crashed IFIX to a new PC. The restore is ok and installed GE9 driver. With the GE9 power tools, we can observed that data transmits and recieve. The problem is that the screen scada is not updating i.e. no status/feedback, anything is happening. The LAN network TCP/IP was configured i.e. IP, subnet and gateway. Any remedies/advice is most welcome. Please provide a guide on the communication/configuration setup. Thanks
Hello, At the plant I work at there are devices with IP addresses starting with 192.168.0, 192,168.1, and 193.168.2 The SLC in question is on 192.168.2 We would like to access it from our laptops which are on 192.168.0 The laptops have their subnet mask set to 255.255.252.0 and we are able to pull see other controllers on the 192.168.2 network. However, for some reason we can't with this one, not even when I'm plugged directly into the Ethernet port on the controller unless we change our IP address to one on 192.168.2 I believe the subnet mask on the controller isn't set right. Can anyone tell what I'm missing here? Here's an overview of the current settings: Laptop: 192.168.0.20, 255.255.252.0 Controller: 192.168.2.17, 255.255.252.0 Any help would be greatly appreciated. Ben