sjanko33
MrPLC Member-
Content count
9 -
Joined
-
Last visited
Community Reputation
0 NeutralAbout sjanko33
-
Rank
Newbie
Contact Methods
- ICQ 0
-
What's the best an quick way to learn RS Logic?
sjanko33 replied to a topic in Allen Bradley / Rockwell Automation
PLC TRAINING OPTIONS: ------------------------------------- 1) To attend training ( Fastest way but could be expensive) If you are in Toronto area I can suggest to you some good one. 2) Buy PLC, good book and study on your own (In long run the best way but could be costly depend of PLC) a) Buy AB MicroLogix 1000 on eBay, find software somewhere and you are ready. b) Buy AutomationDirect DL05 PLC, DirectSoft32 software, cable (approximately $215) and download manuals (cheapest solution). 3) Buy RSLogix 500 software and RSEmulator (pretty expensive) 4) Buy LogixPro from TheLearningPit, that is PLC emulation software (You have demo version on their site) Good luck, Dan -
Chakorules, thanks a lot for advice. How did you get PLC for $89? Everything what I am seeing is much more expensive. Any advice on bidind? Do you have any idea how much will cost SLC 5/04 with 1 DC Input and Output on eBay? Thanks again, Dan
-
Anybody have RSTrainer 2000 for RSLogix 5/500/5000? I have a lot of software that we could exchange. Dan
-
I checked PLCCenter.com but is very expensive. Used-plc.com is much better but still expensive. I am planning to use it for training. Any idea what other AB PLC should I consider? Thanks, Dan
-
Thanks a lot, Dan
-
Do anybody know where can I buy used PLC in Greater Toronto, preferably SLC500 with warranty. I’m interested only in hardware: modular PLC with at list 1 input and output board and Interface cable. Thanks a lot, Dan
-
Any idea how to release the program protection/password?
-
I am pretty sure this option is not checked but I have to check it tomorrow at work. What is purpose of this check box and if it is checked how it would prevent me from downloading? Thanks, Dan
-
Message: Cannot download the program. UM is protected. PLC Software/Hardware: a) CX-Programmer v3.10 b) CQM1-CPU11 c) CQM1-CIF02 Note: CPU Dip SW 1 is OFF (When is On I get the same result) 1) I click “Go online” icon. 2) Message “About to connect to the PLC. Do you wish to continue” OK 3) I click “Transfer to PLC/Download” icon. 4) Window with download options appear. Program only is selected. 5) Message “This command will affect the state of the connected PLC. Continue?” OK 6) Message: Cannot download the program. UM is protected. Please advice, what could be a problem? Regards, Dan