Mantas Rukuiža

MrPLC Member
  • Content count

    3
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Mantas Rukuiža

  • Rank
    Hi, I am New!

Profile Information

  • Country Lithuania
  1. How to set MX2 so it starts ("RUN") automatically after power on

    Config file inverteris2.sdd
  2. How to set MX2 so it starts ("RUN") automatically after power on

    No luck so far.. It's 3-phase setup. I think, basically what i need is  inverter to resume "RUN" after power off.
  3. Hi, i configured MX2 Inverter, using analog buttons to switch it on or off, but on CX-Drive i can't find the option to autostart after it is powered on. I need to press "run" for it to start. I'm sure it is possible, any ideas / guidance much appreciated.