Licardius
MrPLC Member-
Content count
11 -
Joined
-
Last visited
Community Reputation
0 NeutralAbout Licardius
-
Rank
Sparky
Profile Information
- Country Canada
-
Licardius started following Michael Walsh
-
Cant connect scale to CP1H through RS232C Module
Licardius replied to Licardius's topic in CX-Programmer
If I understood correctly, then these are the values that I need? D1000 it is my H1H2 bytes and D1001 it is H3H4? The biggest problem what Scale is still not responding to my signals from TDX(236) -
Cant connect scale to CP1H through RS232C Module
Licardius replied to Licardius's topic in CX-Programmer
This way ? -
Cant connect scale to CP1H through RS232C Module
Licardius replied to Licardius's topic in CX-Programmer
And its interesting why works only D1000-D1004 addresses I think the problem is that the scales do not receive my request command. PLCScalePier6.cxp -
Cant connect scale to CP1H through RS232C Module
Licardius replied to Licardius's topic in CX-Programmer
I see that the values are repeated.And this PLC settings is ok for my situation? -
Licardius liked a post in a topic: Cant connect scale to CP1H through RS232C Module
-
Cant connect scale to CP1H through RS232C Module
Licardius replied to Licardius's topic in CX-Programmer
I have all these bytes go to the same address. If the option is how to separate them? thank you very much -
Licardius liked a post in a topic: Cant connect scale to CP1H through RS232C Module
-
Cant connect scale to CP1H through RS232C Module
Licardius replied to Licardius's topic in CX-Programmer
Thank you a lot . I still do not see a response from the indicator. Where can I find it? PLCScalePier4.cxp -
Cant connect scale to CP1H through RS232C Module
Licardius replied to Licardius's topic in CX-Programmer
Sorry, my level is the most basic for now. I do not quite understand how I can send <STX>?<StatusByte><CR> to my weighing indicator or i need to do it by @TXD(236) transmit? -
Licardius liked a post in a topic: Cant connect scale to CP1H through RS232C Module
-
Licardius liked a post in a topic: Cant connect scale to CP1H through RS232C Module
-
Cant connect scale to CP1H through RS232C Module
Licardius replied to Licardius's topic in CX-Programmer
Thank you a lot. Now I get NET weight from the scales. But now my big problem .I want to receive status from the scales and it is written in the instructions that status can be obtained, but I do not understand what needs to be done to see it. How i get on PLC this H1,H2,H3,H4 bits? Thank you so much. PLCScalePier3.cxp -
I am trying to connect my KILO TECH TOP GUN scale with KIN 500 Indicator to PLC CP1H through RS232C Module (CP1W-0007) . Connect all wires , Comm Light on module is Blinking , But But I see nothing in the program. I tried everything I could, but I didn’t get a result in a couple of days. Thank you very much for your attention . KIN 500 25 september 2013 manual.pdf PLCScale.cxp