bijusi2000

Hi everyone, My plc got a fault, then I power down the PLC => remove the battery => Turn on the PLC until fault led off => Power down the PLC once again => Mount the battery and turn on the PLC. After that, I cannot connect the PLC via either Ethernet or COM port. Please tell me how to factory reset the PLC.   Thanks in advance,

Hi everyone, Now I used Micromaster 430 controlled by a PLC. I set parameters as follows: P0010: 0  P0100: 0 P0700: 2 (using BOP-2) P0701: 1 (start) P0702:12 Terminal 3+4: Connected to Analog output of the PLC  Terminal 5: connected to 24V via a relay which is controlled by the PLC DIP switch1 on (analog input1 with 0-20mA) When I turn on the relay to power to terminal 5, the inverter runs about 5 seconds, then stop automatically while terminal 5 is still powered. There are no fault and no alarm. I checked the parameter P0947 and P2110 with value 0. Especially, when I set P0700 = 1 (using Start button in Panel), the inverter runs well without stop automatically. Please give me some solutions.  

@Steve Bailey It works fine. I used a 2-wire Modbus RTU.  However, I don't know how to get date/time from CPUE05 to HMI.

This what I need to know. Thank you so much.

@Steve Bailey How can I make one which called "PLC_tag" on Proficy Machine Edition for CPUE05 connecting to HMI? Please tell me that. Previous, when I use Proface HMI and Mitsubishi PLC I don't need making any HMI tag and PLC tag.

Many thanks, I will try and give you feedback after testing.

I will try this method. I would like to set CPUE05 Port 2 (RS-485) as Mobus RTU slave and HMI Siemen KTP600 RS422/RS485 as  Modicon RTU master. Is there any wire connection schematic for this?

The HMI supports Modicon Modbus RTU. Is it possible to connect with CPU05?

Hi all, I got a problem when I attempt to try connecting a GE VersaMax CPU05E to a Siemens KTP600 DP which support RS422/RS485 connection. For KTP600, it does not support the GE Fanuc SNP protocol and any OPC driver. Please give me some ideas. Thanks in advanced.