Kabil

MrPLC Member
  • Content count

    5
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Kabil

  • Rank
    Newbie

Profile Information

  • Country India
  1. HI,  Intention:   We have NX701-1700 and NJ 101-1000 plc's and we want to do read/write  service with NX/NJ plc through ethernet IP protocol.  Query 1:     Will you please suggest the command which we can use for read and write job with NX/NJ and the command structure of the same. Query 2:       Will you please share Supported operands and their opcode's for NX701-1700 and NJ 101-1000. Please share the relevant manual document for NX and NJ through ethernetIP protocol. Thanks Kabil
  2. HI,  Intention:   We have NX701-1700 and NJ 101-1000 plc's and we want to do read/write  service with NX/NJ plc through ethernet IP protocol.  Query 1:     Will you please suggest the command which we can use for read and write job with NX/NJ and the command structure of the same. Query 2:       Will you please share Supported operands and their opcode's for NX701-1700 and NJ 101-1000. Please share the relevant manual document for NX and NJ through ethernetIP protocol. Thanks Kabil     
  3. CPU State and CPU Type with OmronEIP Protocol

    HI Michigan,               Thanks for your valuable document.              Can you please suggest how to get the protocol structure for Cpu Type/State with Cx- Designer simulator? Thanks Kabil
  4. Hi,  Any one suggest me the holding memory operand and address of CPU State and CPU Type with CJ and CS Series PLCs.   I could not able to find any documents regarding this topic. Please share any documents regarding this.   Currently we are using SendRRData command for read / write requests. Shall we use the same command for CPU state and CPU type read / write ??   Is it any way available to find the holding memory operand and address of CPU State and CPU Type with CX programmer?   Please share yours valuable inputs. Thanks Kabil