Not sure if I should start a new thread for a little question here? Thought Id hijack this one ;) Sorry geetee1969.
Installed a new set of e3 plus overloads. Need to connect them to existing DeviceNet. Have two cards, each to a powertap, then to a devicebox. Have three sets connected to devicebox already and need to connect the new set. What steps should I take?
We use to just connect one e3 at a time on a set to node 63 and change it to the next node up and so forth, but havent done a new line to the devicebox yet. How do I get the plc to pickup on the new branch?
Hope this makes sense.
Regards