Because PLC CPM2AE made in china has not switch ON/OFF near RS232 port. I have open board and check but pin in position dipswitch have no circuit.
In RS232 on PLC connect HMI used hotlink (9600,7,2,E) but now port not connect to HMI although before connect normally.
Cable RS232 is OK because I used many time: XW2Z-200S-CV.
Cable CIF-01 is ok.
It is difficult for me: no battery, no clear config plc, no reset plc.
Please help me, but not connect I must change CP1E and modul, I must pay money for that change.
May clear PLC?? because I have program PLC before change config.
Thanks you so much !